2027 Outback Yachts Outback 50

• Hull topsides and superstructure in general are foam cored FRP composite, with outer layers utilizing vinylester resins and E-glass reinforcements throughout the structure.
• Hull is solid FRP laminate below the waterline and form cored FRP above.
• All molded FRP parts are finished with high gloss Cook 941 gelcoat
• High density foam or solid laminates are used in areas of concentrated loads from hardware mounting.
• Molded propeller tunnels are recessed into hull reducing draft and shaft angle.
• Main deck is fully cored with flat & cambered sections with transverse & longitudinal support of girders & “hat section” stiffeners.
• SS rubrail 1” extends around perimeter of the yacht at the sheer an includes transom
• Exterior finish in high gloss, low VOC Polynt gel coat
• Boot stripe detail (high gloss black)
• Light grey non-skid walkarounds & foredeck
• Seahawk epoxy barrier coating and bottom paint with limited 3-year osmosis warranty
• Pettit prop protect “barnacle barrier” for underwater metals
• (2) Hull entry doors on port and starboard side

• Twin Volvo Penta D6 480 HP; 6-cylinder, common rail, electronic shift, Tier III emission certified
• Sidepower SEP130 24VDC bow thruster with proportional speed control and SEP stern thruster
• Zipwake Dynamic Control System KB 600-E Interceptors
• Integrated fresh water heat exchanger cooling system
• 24v-80Amp alternator each engine
• 4 blade bronze propellers
• Aquamet #19 propeller shafts
• Tides Marine dripless rudder and shaft seals
• Groco raw water intake strainers & thru hulls
• Engine room blower & vent ducts
• Engine room floor with FRP non-skid sole
• Gloss white engine room
• Fully insulated sound damping material
• Anti-vibration mounts on engine stringers
• Teleflex BA-200 hydraulic steering system (2) station

• Installation is neat and accessible and clearly labeled
• (1) 550-gallon aluminum fuel tank forward of E/R bulkhead
• (2) 2” fill lines. One port and one starboard
• Site gauge on fuel tank
• (2) Racor fuel filters
• (4) Seaflo 24V bilge pumps with 3-way switches and Ultra float switches
• Beckson manual bilge pump
• (2) SS 100-gallon water tanks located at sole.
• Crossover with shutoff valves for filling tanks (port or starboard)
• Jabsco Par Max 4” 24V fresh water pump
• (2) Jabsco accumulator tanks
• (2) Jabsco accumulator tanks
• Whale Marine 10-gallon 120V water heater
• Trionic 14.5 gal 24V sump tank for head sinks & showers
• 80-gallon black water tank
• Sealand T series 24V discharge pump for holding tank
• Sealand Tank Watch 4 depth indicator
• Jabsco seawater deck wash pump
• (3) Freshwater hose coils at bow, stern and flybridge
• Whale Twist Deck shower at transom
• LG front load washer/dryer combo unit

• Northern Lights 12kw generator with sound shield
• Remote start/stop panel for generator at lower helm
• (4) 24V 160/AH AGM house batteries
• (4) 12V AGM Batteries for engine start
• Mastervolt Combimaster 24/2000 120 inverter/charger
• Mastervolt Chargemaster Plus 24V/80 for house service
• Mastervolt Chargemaster 12V/35 for engine batteries
• Mastervolt “Battery Mate” isolator
• Mastervolt converter 24/12-24
• Dometic Marine Air reverse cycle air conditioning and heating system. (2) remote mount 
• compressors with 3 air handlers. 48K BTU system for a tropical climate
• Gas/water separator muffler for quiet generator operation
• AC/DC main control panel located near lower helm
• (2) Marinco shore power outlets 50 amp/110v/220v
• Promariner galvanic isolator and bonding system
• Kraus & Naimer transfer switch for forward or aft shore power
• 110 V outlets throughout accommodations, flybridge, infinity deck and engine room GFCI protected, 
• and waterproof at exterior outlets.
• 24V house system
• BCM LED interior overhead lighting
• Effective lighting in all machinery and storage spaces
• Hella Main deck & exterior safety lighting
• BCM LED exterior overhead Infinity deck lighting
• Hella LED navigation lights

• Muir Windlass VRC1250 24v with 2 station controls and SS chain stopper
• 150’ 3/8"ACCO BBB galvanized chain with 150’ 5/8” nylon anchor line
• Bruce style 66 lb. anchor
• Molded FRP pulpit with SS anchor channel and roller.
• (5)12” SS mooring cleats
• (2) 15” SS mooring cleats at transom
• (2) 10” SS mooring cleat on platform for snubber line
• (2) SS Hawse holes located midships
• (2) SS chocks in way of forward mooring cleats
• Aluminum mast (white powder coat) on flybridge. Hinged to lower bridge clearance to 13'3" with SS saddle holder
• (3) Exalto wiper/washer system with speed control

• L – shaped lounge with seating with custom upholstery
• Molded FRP helm console with 26" SS helm wheel
• Two Stidd 500-N helm chairs with Ultraleather upholstery and powder coated pedestal
• 3” SS stanchions for boat deck support
• Structural lamination and pre-wire for future davit
• SS 1 ¼” safety rails port and starboard and aft with removable rails for tender access
• SS 1 ¼” safety rail surrounding ladder to Infinity deck
• Tinted plexiglass venturi screen
• Dining table with I G Hi-Mac solid surface table top and stainless steel pedestals
• FRP SS framed plexiglass hatch

• Flexiteek decking for entire deck and swim platform
• SS hinged soft angle ladder with integrated handrail and Flexiteek stair treads
• Two Port and starboard FRP bench seats with lift top storage
• Two multi-position tables w/LG Hi-Mac solid surface tabletop and stainless steel pedestals
• Large integrated storage cabinet under galley window
• Large engine room access hatch with dual ram electric hydraulic lift
• Quick access engine room hatch with ladder
• Large generator room access hatch with dual ram electric hydraulic lift
• Lazarette access hatch
• Hatches drain to waterline
• Natural ventilation at aft storage compartment
• SS (3) piece transom railing system with multiple configurations
• SS Rub strake protection at transom corners
• SS retractable swim ladder with cover on platform
• Heavy duty folding SS cleats on platform
• SS 1 ¼” safety handrail from Infinity deck to bow

LOWER HELM:

• Stidd 500-N helm chair with Ultraleather upholstery
• Portside custom upholstered bench seat
• Opening window on port side
• Sliding entry door to starboard side deck
• Volvo Penta engine monitoring systems
• Twin Lever Shift & Throttle Control (EVC-E)
• Triple windshield wipers w/ multiple speed settings
• Windshield washers plumbed from the freshwater system
• Ritchie SS 2000 compass
• Switch controls for horn, running lights, anchor light, engine room blowers, & bilge pumps
• Custom SS spoke steering wheel
• SS Footrest at helm station

FLYBRIDGE HELM:

• (2) Stidd 500-N side-by-side helm chairs
• Volvo Penta engine monitoring systems
• Volvo Shift & Throttle Controls (EVC-E)
• Ritchie SS 2000 compass
• Switch controls for horn, running lights, and anchor light
• Custom 26” SS spoke steering wheel
• Port and starboard lift top gear storage

• Centerline opening door and sliding galley window
• Custom upholstered “L” settee with storage
• (2) Custom upholstered lounge chairs
• Hi-low dining/coffee table with removable leaf
• Samsung 32” LED TV with electric drop down lift
• Fusion Stereo system, amplifier and router with speakers at salon, infinity deck and flybridge
• Mold resistant engineered leather removable headliner
• Storage cabinet
• Gas shock assists for storage/equipment room hatches
• Pull down duette shades
• Amtico “white oak” plank sole

• Large open concept galley with amazing views
• Solid quartz countertops
• Stainless steel under mount Elkay sink
• Single lever polished chrome faucet
• Upper storage cabinets port & starboard
• Thor stainless steel refrigerator drawers
• Summit 15” freezer
• Vitrifrigo Classic Hydro ice maker
• Kenyon 3 burner cooktop
• Bosch speed oven/microwave
• Henckels cutlery set
• Drawers and storage lockers below the counter
• Amtico “white oak” plank sole

• Queen berth with storage drawers below
• White matte finished shiplap cabin sides
• (2) Manship SS opening portlights
• Manship SS overhead hatch with OceanAir sliding screens
• (2) BCM Catalina LED polished reading lights
• Large hanging locker at aft cabin
• Carpeted sole
• Mold resistant engineered leather removable headliner

• Porcelain vessel sink
• Satin finish wood laminate cabinet below sink
• Opening portlight on side
• Mirrored medicine cabinet
• Shower with hinged glass door
• Rule DC ventilation blower
• Full height mirror on head door
• Polished chrome faucets for sink/shower
• Tecma silence plus 2G deep bowl head
• Custom tiled sole

• Twin side by side berths in each cabin with nightstand
• LED Catalina reading lights
• Mold resistant engineered leather removable headliner
• Port lights
• Storage lockers and shelves
• White matte finish shiplap cabin sides
• Carpeted sole

• Porcelain vessel sink
• Satin finish wood laminate cabinet below sink
• Opening portlight on side
• Mirrored medicine cabinet
• Shower with hinged glass door
• Rule DC ventilation blower
• Full height mirror on head door
• Polished chrome faucets for sink/shower
• Tecma silence plus 2G deep bowl head
• Custom tiled sole

• White Oak interior with satin finish throughout
• Master head and shower tile
• Quartz at galley, starboard forward counter, bunkroom nightstand, and head counters
• Quartz at shower seats
• Aft deck port and starboard settee cushions
• Salon settee cushions with pillows
• Two custom upholstered salon chairs
• Port forward upholstered bench seat with pillows
• Master and bunk room duvet covers and pillows
• Upholstered helm console station in black padded vinyl with baseball stitched seams
• Foam mattresses for master and bunk rooms
• Duette shades at main deck
• Carpet at lower level
• Furnishings designed and decorated with high quality fabrics
• Canvas package: Custom exterior Sunbrella canvas covers for settees, tables, helm seat, console and windlass with custom Stamoid forward helm window covers

• 4 - Fenders
• 6 - Braided dock lines
• 12 – Coast guard approved life Jackets
• Electric trumpet horn
• 24-inch life ring
• 3 - Hand-held fire extinguishers [(1) Type-1 and (2) Type-2]
• Flare gun kit
• U.S.C.G. navigation rules
• $60,000 Freight allowance – freight costs above or below will be adjusted accordingly
• Port fees and/or surcharges, if any, are responsibility of owner
• Cargo Insurance responsibility of owner
• Commissioning is included; however, U.S. import duties and tariffs are not included in the listed price. Any applicable tariffs will be determined based on prevailing regulations at the time of importation and are the responsibility of the buyer.
• Offshore Registration fees (Foreign Flagging), if applicable, are responsibility of buyer.

• Tender
• Electronics

Actually 56 feet in length each Outback 50 is built to meet the specific needs of each customer. Some were built with 3 staterooms and 2 heads. Others feature 2 larger staterooms with one or two heads. The galley can be located forward in the deck house or aft. The boat that we currently have in build has three staterooms, two heads, and the galley located aft. There is an illustration of the layout in with the photos. In this presentation we have provided photos of some of the various layouts and features of previous Outback's. The boat we currently have in build will be done in November. We could also start a custom build with delivery in approximately one year or discuss an existing Outback 50 as a brokerage alternative.

Listing MLS by Yachtr.com