1980 Bristol 35.5

Mast:

• Collar (OD) - 26 3/4", Flange 271/2"
• Mast circumference - 221/2"
• Bast to deck light - 29'
• Base to truck shoulder - 52' 4"
• Light mount 10" from masthead
• Electrical Dissipation - Forespar Lightning Master - masthead mount
• Lighting
• Aqua Signal series 40 tri-color/strobe/anchor
• Tri Color Light - Bay 15d 6W 600lm LED
• Anchor - Bay 15d 3W LED

Boom:

• 13' 4" Boom length - mast to topping lift

Sails:

• 140 Genoa with sacrificial - 21' on the foot R/F
• Sobstad 150 Genoa - 23' on the foot R/F
• Working Jib 8 oz. R/F/37' Luff/33'6" Leech - Hood H54413
• Heavy air jib 12 oz R/F - 14' 6" foot/32'6" Luff/27' Leech (Pendants - L 1"2"/U 12'10")
• Spinnaker
• Roller Furling 
• Harken Roll pin fuller dated 1985 - pre MKI (Refurbished by Harken 3/2015)

Winches:

• Genoa - 2 Lewmar Ocean 46 2 2 Speed self tailing
• Halyards - 2 Lewmar 16 2 Speed
• Bridge Deck - 1 Lewmar 16 2 Speed

Electronics:

• Sea View Sail pod SP2S
• GPS Garmin GPS Map 741xs 
• Radar - Garmin GMR 18xHD
• Depth - Raymarine i50
• Wind - Raymarine i60
• Speed - Raymarine i50
• VHS - Standard Horizon GX1700 with GPS
• Remote Mic -standard horizon 
• Stereo - Kenwood BT-368U

• New Cabin Cushions
• New VHF
• New Raymarine i50 and i60
• New Dodger, Bimini and connector with 1" stainless framing
• New Guest dual bank battery charging system
• (2) 12V Batteries
• Stainless steel Atwood water heater
• Galley and head faucets
• Fresh water pump and accumulator tank and replumb with pex water lines
• Foredeck cowl vent
• Replaced all door and cabinet hardware
• Installed new Raritan PHC manual head
• Partial replacement of running rigging - Main halyard, Spinnaker pole halyard
• Refinish cabin doors
• Refinish 50% of locker doors
• Replace shore power connector
• Polish Binnacle to bright stainless

• Refinish remainder of locker doors
• Garmin Radar GMR 18xHD with mount
• Replace bearings in Harken Furler
• Replace all standing rigging - 316SS
• Replace topping lift and lazy jacks
• Replace all mast wiring
• Replace all mast lighting
• Install new sump pump
• New C-Cushions cockpit cushions..
• Install new LED red cabin floor courtesy lighting
• Install new nav station panel for VHS, Stereo blue-tooth, Switch Panel and USB charger
• Install stereo speakers
• Varnish main cabin starboard and port
• Install Standard Horizon VHF GX1700

• Powder coat and clear coat port frames
• Replaced Universal diesel riser mixing elbow
• Replaced Oberdorfer Raw water pump
• Install Minn Kota MK230PC 30 amp 2 bank charging system
• Install 4 New Found Metal opening ports with screens
• Strip and seal table
• Replace Beckson passive ventilator C-6SS internal components
• Replace cabin lighting with Scandvik chromed brass LED fixtures
• Install Weems and Plath oil lamp
• Install 1 new 120 AC circuit breaker and circuit on starboard interior
• Install 3 new 120 AC outlets
• Strip and refinish cabin sole
• Refinish forward cabin

• Bomar Deck Hatches 
•      Removed and refinished (paint and clear coat)
•      Lexan and sealing gaskets replaced
• Toe Rail sanded and finished bright with Interlux Perfection Plus (6 coats)
• Maintenance coats (2) Interlux Perfection Plus on all previously coated exterior surfaces
• Quarter birth refinished – Captains Varnish 1015
• Navigation station removed and refinished – Captains Varnish 1015
• Quarter birth 3 speed Caframo Bora fan installed
• Installed Ocean Marine Systems Outboard Lifting Davit - Model MD20
• Installed 2 - 5 amp 12v circuit breakers for radar and GPS
• Installed Garmin 741xs on temporary fittings

2018:

• Rebuild of 7 Schaefer blocks to include both inboard stand-up cars
• Installed Seaview Sail pod SP2S at helm
•             Moved remote VHF mike to SP2S
• Installed 12V power for spot light in SP2S
• Moved Garmin 741xs to SP2S
• New shelving in port main cabin lockers
• Moved vessel from southern Chesapeake to Sandusky, Ohio - Lake Erie

2019:

• New 30amp 50ft shore power cord
• 100' Stern anchor line ½”
• (2) Super Start Fleet and Heavy Duty AGM Group 24 Deep Cycle 525cca/81ah
•       (purchased from O’reilly Auto Parts)
• New cutlass bearing
• New stainless steel propeller shaft
• Propeller cleaned and balanced
• Magnesium anode propeller lock nut
• Main sail completely cleaned
• Installed new diesel recirculating fresh water pump
• Installed 160 degree engine thermostat replacing 180 degree unit
• Replaced existing with new  Whale Flipper hand pump # GP0418 25’ 5/16" ISO G43 High Test Marine Anchor Chain  WLL 3,900 lb BL 11,600 lb Weight 1.03 lb/ft New Main Sail cover – Sunbrella Silica Dune

2020:

• Hobbs 192.3 - Hurth HB-10 2R rebuilt 
• New Damper plate installed with rebuilt transmission
• New Lenco Heat exchanger installed
• Moved vessel from Sandusky, OH (Lake Erie) to AuGres MI (Lake Huron)

2021:

• 150 Genoa cleaned
• All exterior bright work refinished – interlux perfection plus

Engine and generator hours are as of the date of the original listing and are a representation of what the listing broker is told by the owner and/or actual reading of the engine hour meters. The broker cannot guarantee the true hours. It is the responsibility of the purchaser and/or his agent to verify engine hours, warranties implied or otherwise and major overhauls as well as all other representations noted on the listing brochure.

The company offers the details of this vessel in good faith but cannot guarantee or warrant the accuracy of this information nor warrant the condition of the vessel. A buyer should instruct his agents, or his surveyors, to investigate such details as the buyer desires validated. This vessel is offered subject to prior sale, price change or withdrawal without notice.

Listing MLS by Yachtr.com